油罐清洗作业火灾预防措施

油罐清洗是石油化工行业一项基本的业务活动.目前大型原油储罐、成品油储罐正在逐步推广应用自动机械清洗系统进行清罐作业,而对于容量小、沉积物较少的油罐国内仍然采用人工清洗方式进行.本文分析了油罐人工清洗作业过程中容易引发火灾的原因的基础上,从严格执行规章制度、处理好清洗废物,控制和消除引火源等几方面相应提出了预防火灾措施.     

聚合硅酸硫酸铝铁的制备与应用

在n(Fe A1)／n(Si)为0．5～1．0、n(Al)／n(Fe)为2．5～3．0、SiO2质量分数为2．3％、硅酸钠溶液的活化pH为5．5、硅酸钠溶液的活化时间为12min或SiO2的质量分数为2．0％、硅酸钠溶液的活化pH为6．0、硅酸钠溶液的活化时间为3min的条件下，制备出的聚合硅酸硫酸铝铁对废水的除浊效果最佳，除浊率大于98％。     

我国废铅蓄电池产生量与再生铅产能的讨论

废铅蓄电池是再生铅主要原料，铅蓄电池产量、进出口量、社会消费保有量，以及铅蓄电池消费使用领域与废铅蓄电池产生量有关。预测2015年废铅蓄电池产生量，并讨论我国再生铅产能规模，供再生铅产业结构调整与区域布局调整作参考。     

Stand-alone wind power system with battery/supercapacitor hybrid energy storage

This paper presents a stand-alone wind power system with battery/supercapacitor hybrid energy storage. A stand-alone wind power system mainly consists of a wind turbine, a permanent magnet synchronous generator, hybrid energy storage devices based on a vanadium redox flow battery and a supercapacitor, an AC/DC converter, two bidirectional DC/DC converters, a DC/AC converter and a variable load. Several control strategies for the stand-alone wind power system are involved such as a maximum power point tracking (MPPT) control, a vanadium redox flow battery charge/discharge control and a supercapacitor charge/discharge control. The proposed MPPT control combines a sliding mode control with an extreme search control to capture maximum wind energy. This strategy avoids the necessity of measuring wind velocity, obtaining models or parameters of the wind turbine and calculating the differentials of the power generated from the wind power system and from the speed of the generator. The battery charge/discharge control maintains a constant DC bus voltage. When the battery charging/discharging current reaches the setting threshold, the charge/discharge control of the supercapacitor is triggered to limit the charging/discharging current of the battery. The simulation results show that the proposed method can rapidly respond to variations in wind velocity and load power.     

降水中甲酸、乙酸和草酸的离子色谱法测定及样品保存研究

甲酸、乙酸和草酸是降水中有机酸的主要成分。研究选用离子色谱法同时测定降水中的甲酸、乙酸和草酸,并对降水样品中3种有机酸的保存条件进行了研究。优化后的色谱条件为4. 0 mmol/L Na_2CO_3和1. 2 mmol/L NaHCO_3混合淋洗液,淋洗液流速为1. 0 m L/min,进样体积为200μL,电导池温度为30℃,柱温为室温。甲酸、乙酸和草酸的检出限分别为0. 002、0. 005、0. 005 mg/L,实际降水样品测定时平行样的相对标准偏差为1. 4%～12%,加标回收率为95%～118%。样品采集后需尽快用0. 45μm聚醚砜微孔滤膜过滤,4℃以下冷藏密封保存,2 d内测定。若用氢氧化钠溶液调节p H至8～10,样品可保存7 d。     

Comparative evaluation of sizing of metal hydride (MH) hydrogen storage tank filled with different alloys

This study presents a comparative analysis of sizing of metal hydride tank filled with different alloys. Alloys include solid solutions and intermetallic compounds of the generic families AB₅, AB₂, AB, A₂B. The effects of the different alloys on the sizing of metal hydride hydrogen storage tanks are complicated and depend on many factors. In this paper, a thermoeconomic optimization analysis with a simple algebraic formula was presented for the estimation of optimum metal hydride tank surface area for heat transfer enhancement. The optimum area of the metal hydride tank filled with commercially available different alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) was evaluated and compared by the developed method. The optimum net savings and the value of payback were determined for four alloys. It is found that mathematical model can be employed for the determination of optimum metal hydride tank design and increasing net savings according to alloy types. The optimum areas of the tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) were calculated as 0.136, 0.130, 0.133, and 0.173 m², respectively. The optimum net savings for tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) are about 461.0, 409.3, 419.6, and 979.6 $ and the values of payback are about 1.98, 2.1, 2.17, and 1.37 years, respectively. Excessive area of the metal hydride tank would not be as economical as the optimum tank area. Thermal management of metal hydride tank must be designed for optimum points calculated at which maximum savings occur.     

陕西省油松混交林木质残体储量与腐烂特征

木质残体是油松针阔混交林的重要组成部分,具有多种的生态功能,对生态系统的稳定和发展有着不可忽视的作用。以陕西省黄龙山林区为研究区域,设置1 hm2(100 m×100 m)的固定样地,研究典型油松针阔混交林木质残体的储量组成、优势树种的空间关系、腐烂特征及密度与含水量,研究结果表明:(1)研究区油松针阔混交林内木质残体的总储量为10.73 t·hm–2,倒木是林分内木质残体的主要来源。在径级组成结构上,径级20 cm以上的木质残体储量占总储量的绝大部分。腐烂等级中,以腐烂等级Ⅱ与腐烂等级Ⅲ的木质残体贮量最多;(2)利用线性模型模拟该林分木质残体的分解密度与含水量,其拟合结果显示木质残体的密度随着腐烂等级的增加而呈现下降趋势,而含水量则随着腐烂等级的增加而呈现升高的趋势;(3)林分内主要研究树种(油松、白桦和山杨)之间在小空间尺度上呈负关联,大尺度下呈正关联,顶级树种与先锋树种间达到互利共生,群落具有较大稳定性。林分内种间竞争的结果将为地带性顶级树种油松代替白桦与山杨等先锋树种。天然油松针阔混交林木质残体的贮量组成及腐烂特征反映了该区森林群落演替后期阶段木质残体的结构特征,本文的研究结果为我国黄土高原针阔混交林生态系统的管理和保护以及可持续经营提供科学依据。     

Mg3MnxAl1-xCO3类水滑石衍生NSR催化剂的制备及其性能评价

采用共沉淀法合成了三元类水滑石Mg_3Mn_xAl_(1-x)CO_3,通过高温煅烧得到其衍生氧化物Mg_3Mn_xAl_(1-x)O_m,再经浸渍负载Pt或BaO后制得新型NO_x存储/再还原(NSR)催化剂。XRD及SEM表征结果显示,当Mn与Al的摩尔比(Mn/Al)大于1时所制备的Mg_3Mn_xAl_(1-x)O_m有杂晶相出现且发生团聚,结合NO_x存储性能评价结果,确定最优Mn/Al为1。BaO负载不利于NO_x的存储,而当Pt负载量为1%(w)时NO_x存储性能最优,250℃条件下的存储量由负载前的0.52 mmol/g提升至0.61 mmol/g。CO_2与NO_x之间存在较强的竞争吸附。负载1%Pt催化剂的NSR性能评价结果表明,8个稀燃-富燃循环后NO_x的去除率为68%,表明催化剂的还原性能仍需加强。     

基于SD和CLUE-S模型的区域土地利用变化对土壤有机碳储量影响研究

土地利用/土地覆被变化改变土壤呼吸条件,进而对土壤有机碳储量变化产生影响,而土壤有机碳储量则是影响农业可持续发展和全球碳平衡领域的重要因素。以上海市崇明岛为例,运用系统动力学模型(System Dynamics Model)预测2020、2030年土地利用需求变化,结合CLUE-S模型(Conversion of Land Use and its Effects at Small region extent Model)得出各种用地类型的空间分布,并引用碳密度法估算三种发展幕景下土地利用变化对土壤有机碳储量的影响。结果表明:2030年三种发展幕景土壤有机碳储量分别为:低速发展幕景为3 093.03×106kg,惯性发展幕景为3 079.47×106kg,高速发展幕景为3 059.81×106kg;研究期内土壤有机碳储量呈现缓慢下降趋势,但人类活动对其扰动较小;SD和CLUE-S耦合模型可以从时间和空间两方面对土壤有机碳储量进行模拟,具有可行性;建议通过加强城镇用地集约利用、农田保护、林地建设来减少人为活动对土壤有机碳储量的影响。     

河南省秸秆能源化利用研究

在日益严峻的能源短缺和环境污染的双重压力下,进行秸秆能源化的开发和利用对于河南新型城镇化建设具有重大战略意义.河南秸秆资源丰富,但秸秆能源化利用尚处于初级阶段,利用率非常低,只有健全秸秆收储体系,改进各种秸秆能源化利用方式的技术性能,加强应用和推广,提升秸秆能源化利用的经济效益,加大对秸秆能源化利用相关主体的引导和扶持,提供政策和资金支持,才能为河南秸秆能源化发展提供良好的环境.